Introduction
Every owner of an electronic item has been annoyed by a device that refuses to turn on, even after it has been completely charged. Numerous things, including hardware problems and software bugs, could be the source of this problem. You can follow the instructions in this tutorial to troubleshoot and perhaps fix this issue.

Step 1: Perform a Soft Reset
A soft reset is a simple and risk-free method that can solve minor software glitches. To perform a soft reset:
- Press and hold the power button for about 10-15 seconds.
- Release the button when the device vibrates or you see a logo on the screen.
- Wait for the device to restart.
Step 2: Check the Charging Cable and Adapter
Step 3: Boot in Safe Mode
Booting your device in safe mode can help identify if a third-party app is causing the issue.
- Press and hold the power button until the logo appears.
- As soon as the logo appears, release the power button and immediately hold the volume down button.
- Continue holding the volume down button until the device finishes restarting.
- If “Safe mode” appears at the bottom of your screen, release the volume down button.
Step 4: Factory Reset
If none of the above steps work, you might need to perform a factory reset. Remember, this will erase all data on your device.
- Back up all important data.
- Go to Settings > System > Reset > Factory data reset.
- Follow the on-screen instructions to complete the process.
Conclusion
If your device still won’t turn on after following these steps, it might be a hardware issue. In this case, it’s best to take your device to a professional for repair.
Remember, every device is different. These steps might vary slightly depending on your device’s make and model. Always refer to your device’s user manual for specific instructions.
FAQ's
It’s possible you could also have a damaged charger. Try another cable or power bank, if you have them. You might also want to try another wall outlet or power strip, just to be sure. Check the charging port on the phone itself, too—lint or dirt can easily get caught in there and prevent the pins from making contact.
It could be anything from a memory issue to a video card problem or processor error. Remove any residual electricity by removing the battery, disconnecting the power adapter, and pressing and holding the power button for 30 seconds. Connect the power adapter again, wait 30 seconds, and then turn on the system.
If you see a red light, your battery is fully discharged. If the red light is flashing, there isn’t enough power to turn on. Charge your phone for at least 30 minutes before restarting. If you don’t see a battery icon or red light after you plug in your phone, the issue could be with your screen.
Once it reaches full charge, the charging process stops and only reactivates periodically to maintain the battery at full capacity.
Once it reaches full charge, the charging process stops and only reactivates periodically to maintain the battery at full capacity.